morwen: (Default)
Abigail Brady ([personal profile] morwen) wrote2008-01-01 06:58 pm
Entry tags:

(no subject)

back in london.

my boiler appears to have broken or something over christmas. it's a combination boiler. fails with error A01 which apparently means "failed to ignite". however, it does produce hot water for a couple of minutes after I reset it before then failing again. so either it has an immersion heater or somesuch as well or it did ignite after all?

[identity profile] timeplease.livejournal.com 2008-01-01 07:08 pm (UTC)(link)
Last time I had combi boiler problems (with similar symptoms) it was just the water pressure in the heating circuit being too low. The pressure gauge should read about 1.5 bar.

[identity profile] abigailb.livejournal.com 2008-01-02 08:53 am (UTC)(link)
Seems to be a bit happier now. Water pressure was 1.5 bar when I got back from pub, is around 2 now (with hot water).